Welcome to our supplies of metal gates...
We stock a variety of different metal galvanised gates, including channel end, box end and half mesh. (priced low-high). We also have in stock various hanging and slamming posts, to suit the gates we supply. We always have around 100 gates in stock, ranging from 3 feet to 16 feet long.
The half mesh gates are the most common ones that we sell, as they offer not only a strong barrier but also prevent small livestock from getting through the lower rails (as seen in the photo). They have a 2x2" Box section at the hanging end, and a 2x1" box section at the shutting end, the gates come with 2 x hanging eyes and 1 x spring loaded bolt. These gates range between 3 and 16 feet long. They can be hung as a pair, but a left handed one would be required (special order if the mesh being on the other side was a problem). All gates are 1143mm in height. |
The Box End gate is a standard 7 rail field gate. Its a basic gate which is ideal for general field entrances as they are relatively cheap but a substantial gate to take general farm use. (obviously can be used on drive ways). These gates are supplied with 2 x hanging eyes and 1 x spring loaded bolt. The gates range between 3 and 16 feet and are all 1143mm in height. They can be hung as a pair or individually, as seen in the photo. |
The Channel End gate is very much the same as the Box End gate, apart from instead of a Box section at the hinge end, its a channel instead (to reduce cost and as seen in the photo) these are they cheapest form of galvanised gate that we stock, for light use only, preferably for a gateway that's rarely opened or used. The gate comes with 2 x hanging eyes and 1 x spring loaded bolt. These gates can be hung as a pair or individually. |
We stock a variety of different posts (all suit the gates we supply). We stock 3 types of hanging post which are 4 1/2" in diameter. The most common is a simple hanging posts (hooks welded, with spacing to match eyes). The dual hanging posts allows you to hang two gates, one either side of the post (again with hooks welded, with spacing to match eyes). Finally we stock a security hanging post which is basically the same as a standard hanging post, but the top hook is welded upside down, to prevent intruders lifting the gate off its hinges.
The 4 1/2" slam posts are designed to go at the shutting end of your gate, in which the post has a slot cut out in order for your sliding bolt to secure the gate shut. We also stock a lighter duty 3 1/2" post, we only stock these in a hanging and slamming post. |